FreeBSD (tested on 4.9):
ADDRESS = 2001:918:fffc:12:1::2
GATEWAY= fe80::209:c0ff:fe30:4357
INTERFACE = xl0
|
Add the IPv6 address for the interface |
ifconfig xl0 inet6 add 2001:918:fffc:12:1::2 prefixlen 64 |
|
Remove IPv6 address from the interface |
ifconfig xl0 inet6 2001:918:fffc:12:1::10 prefixlen 64 delete |
|
Autoconfiguration on/off |
sysctl net.inet6.ip6.accept_rtadv=1 |
|
Add specific route to host |
route add -inet6 2001:800:40::1 fe80::209:c0ff:fe30:4357%xl0 |
|
Add specific route to network |
route add -inet6 2001:800:40::/48 fe80::209:c0ff:fe30:4357%xl0 |
|
Remove specific route |
route delete -inet6 2001:800:40::/48 fe80::209:c0ff:fe30:4357%xl0 |
|
Add default IPv6 route |
route add -inet6 ::/0 fe80::209:c0ff:fe30:4357%xl0 |
|
Remove default IPv6 route |
route delete -inet6 ::/0 fe80::209:c0ff:fe30:4357%xl0 |
|
Display current routing table |
netstat -r |
|
Display current interface configuration |
ifconfig |
ADDRESS = 2001:918:fffc:12:1::2
GATEWAY= fe80::209:c0ff:fe30:4357
INTERFACE = Local Area Connection
|
Add the IPv6 address for the interface |
netsh interface ipv6 set address “Local Area Connection” 2001:918:0:12:1::2 |
|
Remove IPv6 address from the interface |
netsh interface ipv6 delete address “Local Area Connection” 2001:918:0:12:1::2 |
|
Enable IPv6 |
Netsh interface ipv6 install |
|
Disable IPv6 |
Netsh interface ipv6 uninstall |
|
Add specific route to host |
netsh interface ipv6 add route 2001:918:fffc:12::/64 “Local Area Connection” |
|
Add specific route to network |
netsh interface ipv6 add route 2001:918:fffc:12::/64 “Local Area Connection” |
|
Remove specific route |
netsh interface ipv6 delete route 2001:918:fffc:12::/64 “Local Area Connection” |
|
Add default IPv6 route |
netsh interface ipv6 add route ::/0 “Local Area Connection” fe80::209:c0ff:fe30:4357 |
|
Remove default IPv6 route |
netsh interface ipv6 delete route ::/0 “Local Area Connection” fe80::209:c0ff:fe30:4357 |
|
Establish v6-in-v4 tunnel |
netsh interface ipv6 add v6v4tunnel “Local Area Connection” <local IPv4 Adress> <Remote IPv4 Adress> netsh interface ipv6 add address “<Tunnel-Name>” \\ netsh interface ipv6 add route (Not tested) |
|
Display current routing table |
netsh interface ipv6 show route |
|
Display current interface configuration |
Ipconfig |
|
IPv6 Firewall disable |
Netsh firewall set adapter “Local Area Connection” filter=disable |
|
IPv6 Firewall enable |
Netsh firewall set adapter “Local Area Connection” filter= enable |
|
Check connectivity |
Ping www.kame.net |
|
Trace route |
Tracert www.kame.net |
|
Disable IPv6 privacy addresses |
netsh interface ipv6 set privacy disabled |
|
Enable IPv6 privacy addresses |
netsh interface ipv6 set privacy enabled |
ADDRESS = 2001:918:fffc:12:1::2 prefixlen 64
GATEWAY= fe80::209:c0ff:fe30:4357
INTERFACE = eth0
|
Add the IPv6 address for the interface |
ifconfig eth0 add 2001:918:fffc:12:1::2/64 |
|
Remove IPv6 address from the interface |
ifconfig eth0 del 2001:918:fffc:12:1::2/64 |
|
Autoconfiguration on |
echo “1″ > /proc/sys/net/ipv6/conf/eth0/accept_ra echo “1″ > /proc/sys/net/ipv6/conf/eth0/autoconf |
|
Autoconfiguration off |
echo “0″ > /proc/sys/net/ipv6/conf/eth0/accept_ra echo “0″ > /proc/sys/net/ipv6/conf/eth0/autoconf |
|
Enable IPv6 |
compile kernel with IPv6 support or modprobe ipv6 (if compiled as module) |
|
Add specific route to host |
route –A inet6 add 2001:800:40::1 gw fe80::209:c0ff:fe30:4357 dev eth0 |
|
Add specific route to network |
route –A inet6 add 2001:800:40::/48 gw fe80::209:c0ff:fe30:4357 dev eth0 |
|
Remove specific route |
route –A inet6 del 2001:800:40::1 gw fe80::209:c0ff:fe30:4357 dev eth0 |
|
Add default IPv6 route |
route –A inet6 add ::/0 gw fe80::209:c0ff:fe30:4357 dev eth0 |
|
Remove default IPv6 route |
route –A inet6 del ::/0 fe80::209:c0ff:fe30:4357 dev eth0 |
|
Display current routing table |
netstat –nr –A inet6 |
|
Display current interface configuration |
ifconfig |
|
Check connectivity |
ping6 www.kame.net |
|
Trace route |
traceroute6 www.kame.net |
原文轉貼自 http://telscom.ch/?p=208
留言列表
Banana-Pi, 樹梅派應用 
